Avaya 4526FX - LLDP configuration using EDM; Configuring LLDP globally using EDM

Variable Value
ChassisType Indicates the chassis type of the device that sent the topology
message.
BkplType Indicates the backplane type of the device that sent the topology
message.
LocalSeg Indicates if the sender of the topology message is on the same Ethernet
segment as the reporting agent.
CurState Indicates the current state of the sender of the topology message. The
choices are:
• topChanged—T
opology information has recently changed.
• heartbeat—Topology information is unchanged.
• new—The sending agent is in a new state.
LLDP configuration using EDM
Use
the
information in this section to configure and view Link Layer Discovery Protocol (LLDP)
global and transmit properties for local and neighbor systems:
Configuring LLDP globally using EDM
Use the following procedure to configure LLDP transmit properties and view remote table
statistics.
Procedure steps
1.
From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostic tree, double-click 802.1AB.
4. In the 802.1AB tree, double-click LLDP.
5. On the work area, click the Globals tab.
6. Edit global LLDP transmit properties.
7. Click Apply .
System configuration using Enterprise Device Manager
284 Configuration — System April 2011