Variable Value
as IP telephones, WLAN access points, and others can be classified
according to their power requirements.
PowerPriority Lets you set the power priority for the specified port to:
• critical
•
high
• low
PowerLimit(watts) Specifies the maximum power that the switch can supply to a port.
The default value is 16W.
Voltage(volts) Indicates the voltage measured in Volts.
Current(amps) Indicates the current measured in amps.
Power(watts) Indicates the power measured in watts.
Configuring Rate Limiting using EDM
Use the following procedure to configure the Rate Limiting for a single port.
Procedure steps
1. From the navigation tree, double-click Edit
.
2. In the Edit tree, double-click Chassis.
3. In the Chassis tree, double-click Ports.
4. On the work area, click the Rate Limit tab.
5. To a rate limit, click a TrafficType row.
6. Double-click the cell in the AllowedRate column.
7. Select a value from the list.
8. Double-click the cell in the Enable column.
9. Select a value from the list—true to enable the traffic type, or false to disable the
traffic type.
Variable definitions
Use the data in this table to configure rate limiting.
Configuring Rate Limiting using EDM
Configuration — System April 2011 239
To Next Page
Loading...
