Avaya 4526FX - Initiating a Cable Diagnostic Test Using EDM

Prerequisites
Ensure that the SFP GBIC port is active.
Procedure steps
1. From the
Device Physical View, click a unit.
2. From the navigation tree, double-click Edit.
3. In the Edit tree, double click Chassis.
4. In the Chassis tree, double-click Ports.
Initiating a cable diagnostic test using EDM
Use this
procedure to initiate and display results for a cable diagnostic test on a specific switch
port, using the Time Domain Reflectometer (TDR).
Procedure steps
1. From the
Device Physical View right-click a port.
2. Click Edit.
3. In the work area, click the TDR tab.
4. Select the StartTest check box.
5. Click Apply.
Variable definitions
Use the data in this table to initiate a cable diagnostic test and help you understand the
TDR
display
.
Variable Value
StartTest When selected, enables the cable diagnostic
test.
Initiating a cable diagnostic test using EDM
Configuration — System April 2011 267