Avaya 4526FX - No Lldp Port Command; No Lldp Med-Network-Policies Command

Table 87: default lldp tx-tlv med command variables
Variables Description
port <portlist> specifies the ports affected by the command
med-capabilities MED Capabilities TLV (MED TLVs are
transmitted only if MED Capabilities TL
Vs
are transmitted). This TLV is enabled by
default.
extendedPSE Extended PSE TLV This TLV is enabled by
default.
inventory Inventory TLVs This TLV is enabled by
default.
location Location Identification TLV This TLV is
enabled by default.
network-policy Network Policy TLV This TLV is enabled by
default.
no lldp port command
The no lldp port command disables LLDP features on the port.
The syntax for the no
lldp port command is
no lldp [port <portlist>] [config notification] [status]
Run the no lldp port command in Interface Configuration command mode.
no lldp med-network-policies command
The no lldp med-network-policies command disables LLDP MED policies for switch
ports.
The syntax for the no lldp med-network-policies command is
no lldp med-network-policies [port <portList>] {voice|voice-
signaling}
Run the no lldp med-network-policies command in Interface Configuration command
mode.
The following table describes the variables for the no lldp med-network-policies
command.
System configuration using ACLI
174 Configuration — System April 2011