Viewing neighbor inventory using EDM
Use this procedure to display LLDP inventory information for the remote system.
Procedure steps
1.
From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostic tree, double-click 802.1AB.
4. In the 802.1AB tree, double-click Port MED.
5. On the work area, click the Neighbor Inventory tab.
Variable definitions
The following table describes the Neighbor Inventory tab fields.
Variable Value
TimeMark Indicates the TimeFilter for this entry.
LocalPortNum Identifies the local port on which the remote
system information is received.
Index Indicates the arbitrary local integer value
used by this agent to identify a particular
MSAP.
An agent is encouraged to assign
monotonically increasing index values to
new entries, starting with one, after each
reboot.
HardwareRev Indicates the vendor-specific hardware
revision string as advertised by the remote
device.
FirmwareRev Indicates the vendor-specific firmware
revision string as advertised by the remote
device.
SoftwareRev Indicates the vendor-specific software
revision string as advertised by the remote
device.
SerialNum Indicates the vendor-specific serial number
as advertised by the remote device.
System configuration using Enterprise Device Manager
332 Configuration — System April 2011
To Next Page
Loading...
