show energy-saver interface <portlist>
Variable definitions
The following table defines optional parameters that you can enter after the show energy-
saver interface command.
Variable Value
<portlist> Specifies a port or range of ports.
Job aid: show energy-saver interface command output
The following figure displays sample output for the show energy-saver interface
command using the <portlist> variable.
Figure 17: show energy-saver interface command output
Enabling the Web server for EDM
You must enable the Web server before you can start Enterprise Device Manager. For
information about enabling the Web server using ACLI, see Avaya Ethernet Routing Switch
4500 Series (NN47205-102.)
Enabling the Web server for EDM
Configuration — System April 2011 209
To Next Page
Loading...
