Configuring the 802.1Q framing TLV using ACLI
Use this
procedure to configure the frame tagging mode for exchanging Layer 2 priority tagging
information between the switch and an Avaya IP phone.
Prerequisites
• Enable LLDP MED capabilities.
• Enable LLDP MED network policies.
• Log on to the Interface Configuration mode in ACLI.
Procedure steps
1. Configure the Layer 2 frame tagging mode by using the following command:
lldp [port <portlist>] vendor-specific avaya dot1q-framing
[tagged | non-tagged | auto]
2. Set the Layer 2 frame tagging mode to default by using the following command:
default lldp [port <portlist>] vendor-specific avaya dot1q-
framing
Variable definitions
Variable Value
<portlist> Specifies a port or list of ports.
[tagged | non-tagged | auto] Specifies the frame tagging mode. Values
include:
• tagged—frames are tagged based on the
tagging
value the Avaya IP phone receives
with the LLDP-MED Network Policy TLV.
• non-tagged—frames are not tagged with
802.1Q priority.
• auto—an attempt is made to tag frames
based on the tagging value the Avaya IP
phone receives with the LLDP-MED
Network Policy TLV. If there is no LLDP-
MED Network Policy information available,
an attempt is made to tag frames based on
server configuration. If that fails, traffic is
transmitted untagged.
The default tagging mode is auto.
Configuring LLDP using ACLI
Configuration — System April 2011 187
To Next Page
Loading...
