HCOutSegs: 20
Displaying IPv6 TCP connections
Use the following procedure to display IPv6 TCP
connections:
Enter the following command:
show ipv6 tcp connections
Displaying IPv6 TCP listeners
Use the following procedure to display IPv6 TCP
listeners:
Enter the following command:
show ipv6 tcp listener
Displaying IPv6 UDP statistics and endpoints
Use the following procedure to display IPv6 UDP statistics and endpoints:
1.
Enter the following command to show UDP statistics.
show ipv6 udp
2. Enter the following command to show UDP endpoints.
show ipv6 udp endpoints
Configuring PoE using ACLI
The following section describes the commands necessary to configure PoE using ACLI:
• Set port power enable or disable on page 126
• Set port power priority on page 126
• Set power limit for channels on page 127
• Set traps control on page 127
• Show main power status on page 127
• Set power usage threshold on page 128
Configuring PoE using ACLI
Configuration — System April 2011 125
To Next Page
Loading...
