Configuring PoE for specific switch unit ports using EDM
Use this
procedure to modify the PoE configuration for a one or more ports on a specific switch
unit.
Procedure steps
1. From the Device Physical View, select one or more ports on a switch unit.
2. From the navigation tree, double-click Edit.
3. In the Edit tree, double-click Chassis.
4. Double-click Ports.
5. In the work area, click the PoE tab.
6. In the unit port row, double-click the cell in the AdminEnable column.
7. Select a value from the list—true to enable PoE for the port, or false to disable PoE
for the port.
8. In the unit port row, double-click the cell in the PowerPriority column.
9. Select a value from the list.
10. In the unit port row, double-click the cell in the PowerLimit(watts) column.
11. Type a value.
12. To configure PoE for other selected ports, repeat steps 6 through 11 .
13. Click Apply .
Variable definitions
Use the data in the following table to modify PoE for a one or more specific ports.
Variable Value
Unit Indicates the switch position in a stack.
Port Indicates the switch port number.
AdminEnable Lets you enable or disable PoE on this port.
By default, PoE is enabled.
System configuration using Enterprise Device Manager
236 Configuration — System April 2011
To Next Page
Loading...
