Avaya 4526FX - Default Lldp Med-Network-Policies Command; Default Lldp Tx-Tlv Command

Variables Description
config notification
Set the config notification to its default value
(disabled).
status
Set the LLDPU transmit and receive status to the
default value (txAndRx).
default lldp med-network-policies command
The default lldp med-network-policies command configures LLDP MED policies
for switch ports to default values.
The syntax for the default lldp med-network-
policies command is:
default lldp med-network-policies [port <portList>] {voice|voice-
signaling}
Run the default lldp med-network-policies command in Interface Configuration
command mode.
The following table describes the variables for the default lldp med-network-
policies command.
Table 83: default lldp med-network-policies command variables
Variable Value
port <portlist>
Specifies the port or ports on which to configure
default LLDP MED policies.
voice
Specifies
the default voice network policy. The default
value is 46.
voice-signaling Specifies the default voice signalling network policy.
default lldp tx-tlv command
The default lldp tx-tlv command sets the LLDP Management
TLVs to their default
values. The syntax for the default lldp tx-tlv command is
default lldp tx-tlv [port <portlist>][port-desc] [sys-name] [sys-
desc] [sys-cap] [local-mgmt-addr]
Run the default lldp tx-tlv command in Interface Configuration command mode.
The following table describes the variables for the default lldp tx-tlv command.
Configuring LLDP using ACLI
Configuration — System April 2011 171