Viewing the PoE conservation level request and 802.1Q framing TLV
configuration using EDM
Use this procedure to display the configuration status of the PoE conservation level request
and 802.1Q framing TL
Vs that the switch can transmit to Avaya IP phones.
Procedure steps
1. From the navigation tree, double-click Edit.
2. In the Edit tree, click Diagnostics.
3. In the Diagnostics tree, click 802.1AB.
4. In the 802.1AB tree, click Avaya.
5. In the work area, click the Local Port tab.
Variable definition
Variable Value
Dot1QFramingRequest Displays the frame tagging mode. Values
include:
• tagged—frames are tagged based on the
tagging
value the Avaya IP phone receives
with the LLDP-MED Network Policy TLV.
• non-tagged—frames are not tagged with
802.1Q priority.
• auto—an attempt is made to tag frames
based on the tagging value the Avaya IP
phone receives with the LLDP-MED
Network Policy TLV. If there is no LLDP-
MED Network Policy information available,
an attempt is made to tag frames based on
server configuration. If that fails, traffic is
transmitted untagged.
The default tagging mode is auto.
PoeConsLevelRequest Specifies the power conservation level to
request for a vendor specific PD. Values
range from 0 to 255. With the default value
of 0, the switch does not request a power
conservation level for an
Avaya IP phone
connected to the port.
Configuring the PoE conservation level request TLV using EDM
Configuration — System April 2011 337
To Next Page
Loading...
