Enabling or disabling LLDP Management Address TLV transmission using
EDM
Use the following procedure to enable or disable the transmission of Management Address
TL
Vs on the local system.
Procedure steps
1. From the navigation tree, double-click Edit.
2. In the Edit tree, click Diagnostics.
3. In the Diagnostics tree, click 802.1AB.
4. In the 802.1AB tree, click LLDP.
5. In the work area, click the Local Management tab.
6. Double-lick the cell in the AddPortsTxEnable column for an IPv4 or IPv6 row.
7. To enable the transmission of Management Address TLVs, select one or more port
numbers.
OR
To disable the transmission of Management Address TLVs, deselect one or more
port numbers.
8. Click Ok.
9. On the toolbar, click Apply.
Viewing LLDP neighbor information using EDM
Use the following procedure to display LLDP properties for the remote system.
Procedure steps
1.
From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostic tree, double-click 802.1AB.
4. In the 802.1AB tree, double-click LLDP.
5. On the work area, click the Neighbor tab.
System configuration using Enterprise Device Manager
296 Configuration — System April 2011
To Next Page
Loading...
