Avaya 4526FX - Viewing LLDP Neighbor Protocol VLAN Information Using EDM

Variable Value
the PVID or does not support port-based VLAN
operation, the value is zero.
Viewing LLDP neighbor protocol VLAN information using EDM
Use the following procedure to display LLDP protocol VLAN properties for the remote
system.
Procedure steps
1.
From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostic tree, double-click 802.1AB.
4. In the 802.1AB tree, double-click Port dot1.
5. On the work area, click the Neighbor Protocol VLAN tab.
Variable definitions
The following table describes the Neighbor Protocol VLAN tab fields.
Variable Value
TimeMark Indicates the TimeFilter for this entry.
LocalPortNum Identifies the local port on which the remote system
information is received.
Index Indicates the arbitrary local integer value used by this
agent to identify a particular MSAP.
An agent is
encouraged to assign monotonically increasing index
values to new entries, starting with one, after each
reboot.
ProtoVlanId Indicates the ID of the port and protocol VLANs
associated with the remote port. A value of zero is
used if the system does not know the protocol VLAN
ID (PPVID).
ProtoVlanSuported Indicates whether the remote port supports port and
protocol VLANs.
ProtoVlanEnabled Indicates whether the port and protocol VLANs are
enabled on the remote port.
System configuration using Enterprise Device Manager
306 Configuration — System April 2011