Avaya 4526FX - Configuring Port-Based AES Using ACLI; Activating or Deactivating AES Manually Using ACLI

Variable Value
Important:
You must disable AES globally before you
can modify POE power saving.
Configuring port-based AES using ACLI
Use the following procedure to enable or disable energy saving for the accessed port, an
alternate individual port, or a range of ports.
Prerequisites
•
Disable
AES globally.
• Log on to the Interface Configuration mode in ACLI.
Procedure steps
Configure port-based AES by using the following command:
[default] [no] energy-saver <enable> [port <portlist> enable]
Variable definitions
The following table defines optional parameters that you enter after the [default] [no]
energy-saver <enable> [port <portlist> enable] command.
Variable Value
<enable> Enables AES for the accessed port.
[no] Disables AES for the accessed port, an
alternate port, or list of ports.
port <portlist> enable Enables AES for a port or list of ports.
Activating or deactivating AES manually using ACLI
Use the following procedure to have AES enabled, but not activated.
Activate AES to ensure
that AES is enabled and activated.
System configuration using ACLI
202 Configuration — System April 2011