Variable definitions
Use the data in this table to configure AUR.
Variable Value
AutoUnitReplacementEnabled Enables or disables the auto-unit-
replacement feature.
AutoUnitReplacementSaveEnabled Enables or disables the auto-unit-
replacement automatic
saving of unit images
to the base unit.
AutoUnitReplacementForceSave Forcefully saves the configuration of a
particular non base unit configuration to the
base unit.
AutoUnitReplacementRestore Forcefully restores the configuration of a
particular unit from the saved configuration
on the base unit.
Configuring a switch stack base unit using EDM
Use this procedure to configure a stack base unit status and to display base unit
information.
Procedure steps
1. From the navigation tree, double-click Edit.
2.
In the Edit tree, double-click Chassis .
3. In the Chassis tree, double-click Switch/Stack.
4. In the work area, click the Base Unit Info tab.
5. In the AdminStat section, click a radio button.
6. In the Location section, type a character string.
7. Click Apply .
Configuring a switch stack base unit using EDM
Configuration — System April 2011 227
To Next Page
Loading...
