Avaya 4526FX - Managing the License File Using EDM

Procedure steps
Procedure steps
1. From the navigation tree, double-click Edit.
2.
In the Edit tree, double-click File System.
3. On the work area, click the ASCII Config Script Files tab.
4. In the table, double click the cell under the ScriptSource header.
• If you retrieve the configuration file from a TFTP server, type the IP address of
the desired TFTP server and the name under which the configuration file is
stored in the following format—tftp://<ip address>/<filename>.
• If you retrieve the configuration file from a USB storage device, and the USB
device is inserted in a stand-alone unit, type the name under which the
configuration file is stored in the following format—usb://<filename>.
• If you retrieve the configuration file from a USB storage device, and the USB
device is inserted in a unit of a stack, type the name under which the
configuration file is stored in the following format— usb://<unit number>/
<filename>.
• If you retrieve the file from a BOOTP server, type bootp://.
5. Double-click the cell under the ScriptBootPriority header.
6. Type the priority of the script (between 1 and 127, or 0 for not using the entry at boot
time).
7. On the toolbar, click Apply.
Managing the license file using EDM
Use this procedure to download, install, or remove a license file for the switch.
Important:
When you use the TFTP
address parameter to perform copy or download commands, the
system overwrites the TFTP server address
Procedure steps
1. From the navigation tree, double-click Edit
.
2. In the Edit tree, double-click File System.
System configuration using Enterprise Device Manager
246 Configuration — System April 2011