• Location Identification TLV
• Extended Power-via-MDI TLV and Inventory TLV
You can also configure the following timers:
• Reinitialisation Delay
• Transmit Interval
• Transmit Delay
• Transmit Hold
• Fast Start Timers
• LLDP Timers
• SNMP Notification Interval
802.1AB integration
With 802.1 AB, Link Layer Discovery Protocol (LLDP) integration you can simplify the
deployment
of Avaya voice solutions with Avaya data products because 802.1 AB integration
supports a set of Avaya-specific TLVs that you can use to provision and report about
parameters that support Avaya IP Telephones. When you use the 802.1AB integration TLVs,
you achieve a more rapid deployment of voice solutions and you can also view information
from the data network about the services the voice solutions use. 802.1AB integration also
works with Avaya Energy Saver to maximize off-peak power savings for network and voice
services without impact to service.
New 802.1AB default parameters
Beginning with
Release 5.5, you can improve Voice and Video over IP function because some
of the LLDP parameters are enabled by default. Now you can connect LLDP enabled IP
handsets to the switch and start deployment without additional configuration. The following
LLDP parameters are enabled by default:
• lldp config-notification
• lldp status txAndRx config-notification
• lldp tx-tlv local-mgmt-addr | port-desc | sys-desc | sys-name
• lldp tx-tlv dot3 mdi-power-support
• lldp tx-tlv med extendedPSE | inventory | location | med-capabilities | network-policy
• lldp med-network-policies voice | dscp 46 | priority 6
New in this release
12 Configuration — System April 2011
To Next Page
Loading...
