Variable Value
TimeMark Indicates the TimeFilter for this entry.
LocalPortNum Identifies the local port on which the remote
system information is received.
Index Indicates the arbitrary local integer value
used by this agent to identify a particular
MSAP.
An agent is encouraged to assign
monotonically increasing index values to
new entries, starting with one, after each
reboot.
PSEPowerAvailable Specifies the power available (in units of 0.1
watts) from the PSE connected remotely to
this port.
PSEPowerSource Defines the type of PSE Power Source
advertised by the remote device.
• primary: indicates that the device
advertises its power source as primary.
• backup: indicates that the device
advertises its power source as backup.
PSEPowerPriority Specifies the priority advertised by the PSE
connected remotely to the port:
• critical: indicates that the device advertises
its power priority as critical, see RFC
3621.
• high: indicates that the device advertises
its power priority as high, see RFC 3621.
• low: indicates that the device advertises its
power priority as low, see RFC 3621.
Viewing neighbor PoE PD information using EDM
Use this procedure to display LLDP PoE PD information for the remote system.
Procedure steps
1.
From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostic tree, double-click 802.1AB.
System configuration using Enterprise Device Manager
330 Configuration — System April 2011
To Next Page
Loading...
