4. In the 802.1AB tree, double-click Port MED.
5. On the work area, click the Neighbor PoE PD tab.
Variable definitions
The following table describes the Neighbor PoE PD tab fields.
Variable Value
TimeMark Indicates the TimeFilter for this entry.
LocalPortNum Identifies the local port on which the remote
system information is received.
Index Indicates the arbitrary local integer value
used by this agent to identify a particular
MSAP.
An agent is encouraged to assign
monotonically increasing index values to
new entries, starting with one, after each
reboot.
PDPowerReq Specifies the value of the power required (in
units of 0.1 watts) by a Powered Device (PD)
connected remotely to the port.
PDPowerSource Defines the type of Power Source advertised
as being used by the remote device:
• fromPSE: indicates that the device
advertises its power source as received
from a PSE.
• local: indicates that the device advertises
its power source as local.
• localAndPSE: indicates that the device
advertises its power source as using both
local and PSE power.
PDPowerPriority Defines the priority advertised as being
required by the PD connected remotely to the
port:
• critical: indicates that the device advertises
its power priority as critical, see RFC
3621.
• high: indicates that the device advertises
its power priority as high, see RFC 3621.
• low: indicates that the device advertises its
power priority as low, see RFC 3621.
LLDP Port MED configuration using EDM
Configuration — System April 2011 331
To Next Page
Loading...
