Avaya 4526FX - Viewing the Switch Call Server IP Address TLV Configuration Using ACLI

Prerequisites
Log on to the Global Configuration mode in ACLI.
Procedure steps
1. Define the local call server IPv4 addresses the switch advertises to Avaya IP phones
by using the following command:
lldp vendor-specific avaya call-server [<1-8>] <A.B.C.D>
[[<1-8>] <A.B.C.D>] [[<1-8>] <A.B.C.D>]
2. Delete call server IPv4 addresses configured on the switch by using the following
command:
default lldp vendor-specific avaya call-server <1-8>
Variable definitions
Variable Value
<1-8> Specifies the call server number.
Note:
When you advertise the IPv4 address of
call server
1 only, you do not have to enter
a call server number before you enter the
IP address.
<A.B.C.D> Specifies the call server IPv4 address.
Viewing the switch call server IP address TLV configuration using
ACLI
Use this procedure to display information about the defined local call server IP address that
switch ports advertise to connected
Avaya IP phones.
The switch supports a maximum of 8 local call servers.
Prerequisites
Log on to the Privileged EXEC mode in ACLI.
Procedure steps
Display call server TLV configuration information for the local switch by using the
following command:
Configuring LLDP using ACLI
Configuration — System April 2011 183