Avaya 4526FX - Lldp Tx-Tlv Command

Variable Value
• tagged—uses a tagged VLAN
• untagged—uses an untagged VLAN or does not
support port-based VLANs.
If you select untagged, the system ignores the VLAN
ID
and priority values, and recognizes only the DSCP
value.
vlan-id <0-4094>
Specifies the VLAN identifier for the selected port or
ports. Values range from 0–4094 (0 is for priority
tagged frames). If you select priority tagged frames,
the system recognizes only the 802.1p priority level
and uses a value of 0 for the VLAN ID of the ingress
port.
lldp tx-tlv command
The lldp tx-tlv command sets the optional Management
TLVs to be included in the
transmitted LLDPDUs.
The syntax for the lldp tx-tlv command is:
lldp tx-tlv [port <portlist>] [local-mgmt-addr] [port-desc] [sys-cap]
[sys-desc][sys-name]
Run the lldp tx-tlv command in Interface Configuration command mode.
The following table describes the variables for the lldp tx-tlv command.
Table 77: lldp tx-tlv command variables
Variables Description
local-mgmt-addr
The local management address TLV. This TLV is
enabled by default.
port-desc
The port description TLV This TLV is enabled by
default. This
TLV is enabled by default.
port <portlist> Specifies a port or list of ports.
sys-cap The system capabilities TLV.
sys-desc
The system description TLV. This TLV is enabled by
default.
sys-name
The system name TLV. This TLV is enabled by
default.
Configuring LLDP using ACLI
Configuration — System April 2011 167