Avaya 4526FX - Setting the Asset ID String to Default; AES Configuration Using ACLI; Configuring Global AES Using ACLI

Setting the asset ID string to default
Perform this procedure to set the asset ID string to default mode.
Prerequisites
Log on to Global configuration mode.
Procedure steps
1. T
o set the asset ID string to default enter the following command:
default asset-id [ stack | unit <1-8> | <cr> ]
2. To verify the asset ID string settings enter the following command:
show system
Variable definitions
Use the data in the following table to complete this procedure.
Variable Value
Stack Sets the default Asset ID of the stack
Unit <1-8> Sets the default Asset ID for specified unit Unit number:
1–8
AES configuration using ACLI
You can use
Avaya Energy Saver (AES) to configure the switch to utilize energy more
efficiently.
Configuring global AES using ACLI
Use the following procedure to enable or disable the energy saving feature for the switch.
System configuration using ACLI
200 Configuration — System April 2011