Prerequisites
Log on to the Privileged EXEC mode in ACLI.
Procedure steps
Display the received Layer 2 frame tagging mode information for one or more switch
ports by using the following command:
show lldp [port <portlist>] neighbor vendor-specific avaya
dot1q-framing
Variable definitions
Variable Value
<portlist> Specifies a port or list of ports.
Enabling Avaya TLV transmit flags using ACLI
Use this
procedure to enable the transmission of optional proprietary Avaya TLVs from switch
ports to Avaya IP phones.
Important:
The switch transmits configured A
vaya TLVs only on ports with the TLV transmit flag
enabled.
Prerequisites
Log on to the Interface Configuration mode in ACLI.
Procedure steps
Select the Avaya TLVs that the switch transmits by using the following command:
[default] lldp tx-tlv [port <portList>] vendor-specific avaya
{[poe-conservation] [call-server] [file-server] [dot1q-
framing]}
Variable definitions
Variable Value
call-server Enables the call server TLV transmit flag.
default Sets the TLV transmit flag to the default value of
true (enabled).
dot1q-framing Enables the Layer 2 priority tagging TLV transmit
flag.
Configuring LLDP using ACLI
Configuration — System April 2011 189
To Next Page
Loading...
