Avaya 4526FX - Restoring Configuration from an ASCII File

Table 21: copy config tftp command parameters
Parameters Description
Address The IP address of the TFTP server.
<filename> The name of the file to be retrieved.
copy config usb command
Use the copy config usb command to store a configuration file to a USB Mass Storage
Device. The syntax for the copy config usb command is:
copy config usb {filename <filename> | unit <1-8>
The
copy config usb command is executed in the Privileged EXEC command mode.
Table 22: copy config usb command parameters on page 88 outlines the parameters for the
copy config usb command.
T
able 22: copy config usb command parameters
Parameters Description
<filename> The name of the file to be retrieved.
<1-8> The unit number in which the USB device is
inserted in, if the unit is a part of the stack .
Restoring configuration from an ASCII file
You can restore the configuration from an
ASCII file using the following commands:
•
configure { network | usb } command on page 88
• script command on page 89
configure { network | usb } command
Use the configure {network | usb} command to restore contents of the current
configuration from an
ASCII file. The syntax for the configure {network | usb} is:
configure {network [address <A.B.C.D>] filename <filename>| usb
filename <filename> [unit <1-8>]}
The configure {network | usb} command is executed in the Privileged EXEC command
mode.
System configuration using ACLI
88 Configuration — System April 2011