Chapter 7: System configuration using
Enterprise Device Manager
This chapter provides procedures you can use to configure the switch or stack with Enterprise Device
Manager (EDM).
Configuring Quick Start using EDM
Perform this procedure to configure Quick Start to enter the setup mode through a single
screen.
Procedure steps
1. From the navigation tree, double-click Administration
.
2. In the Administration tree, double-click Quick Start .
3. In the IP/Community/Vlan work area, type a switch or stack IP address in the In-
Band Stack IP Address dialog box.
4. In the In-Band Stack Subnet Mask dialog box, type a subnet mask.
5. In the Default Gateway dialog box, type an IP address.
6. In the Read-Only Community String box, type a character string.
7. In the Re-enter to verify dialog box immediately following the Read-Only
Community String box, retype the character string from Step 6.
8. In the Read-Write Community String dialog box, type a character string.
9. In the Re-enter to verify dialog box immediately following the Read-Write
Community String: box, retype the character string from Step 8.
10. In the Quick Start VLAN dialog box, type a VLAN ID ranging from 1 to 4094.
11. Click Apply .
Configuration — System April 2011 211
To Next Page
Loading...
