Variable Value
AutoNegSupported Indicates the truth value used to indicate whether the
given port
(associated with a remote system) supports
Auto-negotiation.
AutoNegEnabled Indicates whether Auto-negotiation is enabled on the
remote port.
AutoNegAdvertisedCap Contains the value (bitmap) of the
ifMauAutoNegCapAdvertisedBits object (defined in
IETF RFC 3636) associated with the remote port.
OperMauType Indicates the value that indicates the operational MAU
type of the given port on the remote system.
Viewing LLDP neighbor PoE information using EDM
Use the following procedure to display LLDP PoE properties for the remote system.
Procedure steps
1.
From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostic tree, double-click 802.1AB.
4. In the 802.1AB tree, double-click Port dot3.
5. On the work area, click the Neighbor PoE tab.
Variable definitions
The following table describes the Neighbor PoE tab fields.
Variable Value
TimeMark Indicates the TimeFilter for this entry.
LocalPortNum Indicates the local port on which the remote system
information is received.
Index Indicates the arbitrary local integer value used by this
agent to identify a particular MSAP.
An agent is
encouraged to assign monotonically increasing index
values to new entries, starting with one, after each
reboot.
PowerPortClass Indicates the port Class of the remote port.
LLDP Port dot3 configuration using EDM
Configuration — System April 2011 313
To Next Page
Loading...
