Avaya 4526FX - Configuring IPv6 global properties using EDM

Variable definitions
Use the
data in this table to help you understand the currently loaded and operational software
status display.
Variable Value
Unit 1 Software Image version Indicates the loaded agent software image
for the switch or stack.
Unit 1 Software Image in flash Indicates the operational agent software
image for the switch or stack.
Unit 1 Diag Image version Indicates the loaded diagnostic software
image for the switch or stack.
Unit 1 Diag Image in flash Indicates the operational diagnostic software
image for the switch or stack.
Important:
When the currently loaded and operational software status is displayed for a stack, the
unit number is replaced by the word All.
Configuring IPv6 global properties using EDM
Use the following procedure to configure IPv6 global properties.
Procedure steps
1.
From the navigation tree, double-click IPv6
.
2. In the IPv6 tree, double-click IPv6.
3. On the work area, click the Globals tab.
4. Configure the IPv6 globally.
5. On the toolbar, click Apply to save the changes.
6. Click Refresh to display updated information.
Configuring IPv6 global properties using EDM
Configuration — System April 2011 249