Viewing the switch 802.1Q Framing TLV configuration using ACLI
Use this procedure to display the configured Layer 2 frame tagging mode for switch ports.
Prerequisites
Log on to the Privileged EXEC mode in ACLI.
Procedure steps
Display the configured Layer 2 frame tagging mode for one or more switch ports by
using the following command:
show
lldp
[port
<portlist>]
vendor-specific
avaya
dot1q-framing
Variable definitions
Variable Value
<portlist> Specifies a port or list of ports.
Job aid: show lldp vendor-specific avaya dot1q-framing command output
The following figure displays sample output for the show lldp vendor-specific avaya dot1q-
framing command.
Viewing Avaya IP phone 802.1Q Framing TLV information using
ACLI
Use this
procedure to display Layer 2 frame tagging mode information received on switch ports
from connected Avaya IP phones.
System configuration using ACLI
188 Configuration — System April 2011
To Next Page
Loading...
