show interfaces command
The show interfaces command displays the current configuration and status of all
interfaces.
The syntax for the show interfaces command is
show interfaces [names] [<portlist>] [gbic-info]
Run the show interfaces command in User EXEC command mode.
The following table describes the variables for the show interfaces command.
T
able 56: show interfaces variables
Variables Description
names <portlist> Display interface names; enter specific ports to see only those
ports.
gbic-info Display GBIC details.
LINE Display a list of existing ports with names (displays interface
names).
Displaying configuration information for ports
The show port enhancement provides the ability to show all the configuration information for
a specific port through ACLI.
The syntax for the show port enhancement command is: .
show interfaces <portlist> config
The command displays information related to port configuration, VLAN interface, VLAN port
member
, and Spanning-Tree configuration.
The following example displays sample output for the show port enhancement:
show interfaces 1/22 config
General switch administration using ACLI
Configuration — System April 2011 139
To Next Page
Loading...
