Avaya 4526FX - Enabling Flow Control

default autotopology command
The default autotopology command enables the Autotopology protocol.
The syntax for the
default autotopology command is
default autotopology
Run the default autotopology command in Global Configuration command mode.
The default autotopology command has no parameters or values.
show autotopology settings command
The show autotopology settings command displays the global autotopology settings.
The syntax for the show autotopology settings command is
show autotopology settings
Run the show autotopology settings command in Privileged EXEC command mode.
The show autotopology settings command has no parameters or values.
show autotopology nmm-table command
The show autotopology nmm-table displays the Autotopology network management
module (NMM) table.
The syntax for the show autotopology nmm-table command is
show autotopology nmm-table
Run the show autotopology nmm-table command in Privileged EXEC command
mode.
The show autotopology nmm-table command has no parameters or values.
Enabling flow control
Gigabit Ethernet, when used with the Avaya Ethernet Routing Switch 4500 Series, can control
traffic on this port using the flowcontrol command.
Important:
Due to Quality of Service (QoS) interaction, the switch; cannot send pause-frames.
General switch administration using ACLI
Configuration — System April 2011 145