Avaya 4526FX - Configuring remote access using EDM

Configuring remote access using EDM
Use this procedure to configure remote access for a switch.
Procedure steps
1. From the navigation tree, double-click Administration
.
2. In the Administration tree, double-click Remote Access .
3. In the work area, click the Setting tab.
4. In the Telnet Remote Access Setting section, select a value from the Access list.
5. In the Telnet Remote Access Setting section, select a value from the Use List list.
6. In the SNMP Remote Access Setting section, select a value from the Access list.
7. In the SNMP Remote Access Setting section, select a value from the Use List
list.
8. In the Web Page Remote Access Setting section, select a value from the Use List
list.
9. In the SSH Remote Access Setting section, select a value from the Access list.
10. In the SSH Remote Access Setting section, select a value from the Use List list.
11. Click Apply .
Variable definitions
Use the data in this table to configure remote access for a switch.
Variable Value
Telnet Remote Access Setting Specifies the remote access settings for
telnet sessions.
• Access—allows or disallows telnet access
to the switch
• Use List—enables (Yes) or disables (No)
the use of listed remote Telnet
information.
SNMP Remote Access Setting Specifies SNMP remote access settings.
System configuration using Enterprise Device Manager
212 Configuration — System April 2011