Important:
Only Ethernet ports on switches that support PoE can request a specific power conservation
level for an Avaya IP phone.
Variable definitions
Variable Value
<0-255> Specifies the power conservation level to
request for a vendor specific PD. Values
range from 0 to 255. With the default value
of 0, the switch does not request a power
conservation level for an
Avaya IP phone
connected to the port.
<portList> Specifies a port or list of ports.
Viewing the switch PoE conservation level request TLV
configuration using ACLI
Use this procedure to display Poe conservation level request configuration for local switch
ports.
Prerequisites
Log on to the Privileged EXEC mode in
ACLI.
Procedure steps
Display the PoE conservation level request configuration for one or more switch ports
by using the following command:
show lldp [port <portlist>] vendor-specific avaya poe-
conservation-request-level
Variable definitions
Variable Value
<portlist> Specifies a port or list of ports.
Job aid: show lldp vendor-specific avaya poe-conservation-request-level
command output
The following
figure displays sample output for the show lldp vendor-specific avaya
poe-conservation-request-level command.
Configuring LLDP using ACLI
Configuration — System April 2011 181
To Next Page
Loading...
