Variable definitions
The following table describes the Neighbor Link Aggregate tab fields.
Variable Value
TimeMark Indicates the TimeFilter for this entry.
LocalPortNum Indicates the local port on which the remote system
information is received.
Index Indicates the arbitrary local integer value used by this
agent to identify a particular MSAP.
An agent is
encouraged to assign monotonically increasing index
values to new entries, starting with one, after each
reboot.
LinkAggStatus Specifies the link aggregation capabilities and the
current aggregation status of the remote link.
LinkAggPortId Contains the IEEE 802.3 aggregated port identifier,
aAggPortID (IEEE 802.3-2002, 30.7.2.1.1), derived
from the ifNumber of the ifIndex for the port component
in link aggregation. If the port is not in a link
aggregation state or does not support link
aggregation, this value is set to zero.
Viewing LLDP neighbor maximum frame information using EDM
Use the following procedure to display LLDP maximum frame size properties for the remote
system.
Procedure steps
1.
From the navigation tree, double-click Edit.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostic tree, double-click 802.1AB.
4. In the 802.1AB tree, double-click Port dot3.
5. On the work area, click the Neighbor Max Frame tab.
Variable definitions
The following table describes the Neighbor Max Frame tab fields.
LLDP Port dot3 configuration using EDM
Configuration — System April 2011 315
To Next Page
Loading...
