Variable Value
RecurringEndDay Specifies the day of the particular month you
want recurring daylight savings time to end.
RecurringEndHour Specifies the hour of the particular day you
want recurring daylight savings time to end.
RecurringEndMinute Specifies the minutes of the particular hour
you want recurring daylight savings time to
end.
RecurringOffset Specifies the time in minutes by which you
want to change the time when recurring
daylight savings
begins and ends. The offset
is added to the current time when daylight
saving time begins and subtracted from the
current time when daylight saving time
ends.
Viewing network topology information using EDM
Use this procedure to display network topology information.
Procedure steps
1. From the navigation tree, double-click Edit
.
2. In the Edit tree, double-click Diagnostics.
3. In the Diagnostics tree, double-click Topology.
4. In the work area, click the Topology tab.
5. In the Status section, click a radio button..
6. Click Apply .
Variable definitions
Use the data in this table to help you understand the topology display.
Variable Value
IpAddr Indicates the IP address of the device.
System configuration using Enterprise Device Manager
282 Configuration — System April 2011
To Next Page
Loading...
