13. In RecurringEndHour, make a selection from the drop-down list.
14. In the RecurringEndMinute dialog box, type a value from 0 to 59.
15. In the RecurringOffset dialog box, type a value from 1 to 1440.
16. On the tool bar, click Apply.
Variable definitions
Use the data in this table to configure recurring daylight saving time.
Variable Value
Recurring When selected, enables daylight saving time
to recur yearly.
RecurringStartMonth Specifies the month of each year you want
recurring daylight savings time to start.
RecurringStartW
eek Specifies the week of the month you want
recurring daylight savings time to start. Week
5 may not apply in certain years. In that case
summer time start falls back to the 'last'
option. For example: in a year where there is
no Sunday in the fifth week of March,
summer time will start on the last Sunday of
March.
RecurringStartDay Specifies the day of the particular month you
want recurring daylight savings time to
start.
RecurringStartHour Specifies the hour of the particular day you
want recurring daylight savings time to
start.
RecurringStartMinute Specifies the minutes of the particular hour
you want recurring daylight savings time to
start.
RecurringEndMonth Specifies the month of each year you want
recurring daylight savings time to end.
RecurringEndWeek Specifies the week of the month you want
recurring daylight
savings time to end. Week
5 may not apply in certain years. In that case
summer time start falls back to the 'last'
option. For example: in a year where there is
no Sunday in the fifth week of October,
summer time will end on the last Sunday of
October.
Configuring recurring daylight saving time using EDM
Configuration — System April 2011 281
To Next Page
Loading...
