Procedure steps
1. From the navigation tree, double-click Edit
.
2. In the Edit tree, double-click SNTP/Clock.
3. In the work area, click the Simple Network Time Protocol tab.
4. In the PrimaryServerInetAddressType section, click a radio button.
5. In the PrimaryServerInetAddress dialog box, type a value.
6. In the SecondaryServerInetAddressType section, click a radio button.
7. In the SecondaryServerInetAddress dialog box, type a value.
8. In the State section, click a radio button.
9. In the SyncInterval dialog box, type a value.
10. In the ManualSyncRequest section, click the requestSync radio button to
synchronize the switch with the NTP server.
11. Click Apply .
Variable definitions
Use the data in this table to configure SNTP
.
Variable Value
PrimaryServerInetAddress Type
Specifies the primary SNTP server IP address type.
Values include ipv4 and ipv6.
PrimaryServerInetAddress
Specifies the IP address of the primary SNTP
server.
SecondaryServerInetAddress Type
Specifies the secondary SNTP server IP address
type. Values include ipv4 and ipv6.
SecondaryServerInetAddress
Specifies the IP address of the secondary SNTP
server.
State Specifies if the switch uses SNTP to synchronize the
switch clock to the Coordinated Universal Time
(UTC).
• disabled—the device cannot synchronize its clock
using SNTP
• enabled (unicast)—the device synchronizes to
UTC shortly after start time when network access
becomes available, and periodically thereafter
System configuration using Enterprise Device Manager
276 Configuration — System April 2011
To Next Page
Loading...
