Important:
If the switch CPU is busy performing other tasks, the output of the show running-config
command can appear to intermittently stop and start. This is normal operation to ensure that
other switch management tasks receive appropriate priority.
Important:
The ASCII
configuration generated by the show running-config command produces a
file in which the IP address of the switch is inactive by being commented out using the '!'
character. This enables customers to move the configuration between switches without
causing issues with duplicate IP addresses.
Variable definitions
The following table defines optional parameters that you can enter after the show running-
config command.
Variable Value
module <value> Display configuration of an application for
any of the following parameter values:
[802.1ab] [aaur] [adac] [arp-inspection]
[asset-id] [aur] [banner] [core] [dhcp-relay]
[dhcp-snooping] [eap] [energy-saver]
[interface] [ip]
[ip-source-guard] [ipfix] [ipmgr]
[ipv6] [l3] [l3-protocols] [lacp] [logging] [mac-
security] [mlt] [nsna] [port-mirroring] [qos]
[rate-limit] [rmon] [rtc] [snmp] [ssh] [ssl]
[stack] [stkmon] [stp] [vlacp] [vlan]
verbose Display entire configuration, including
defaults and non-defaults.
Job aid: show running-config command output
The following tables show sample output for variations of the show running-config
command.
Table 15: show running-config module mlt command output
ERS-4524GT#
show running-config module mlt
! Embedded ASCII Configuration Generator Script
! Model = Ethernet Routing Switch 4524GT
! Software version = v5.4.0.057
!
! Displaying only parameters different to default
System configuration using ACLI
78 Configuration — System April 2011
To Next Page
Loading...
