The syntax for the script command is:
script <1-127> {bootp | load-on-boot <1-127> | tftp <hostname | IP>
<filename>| usb [unit<1-8>] <filename>}
The script command is executed in the Global Configuration command mode.
Table 18: script parameters on page 86 outlines the parameters for this command.
T
able 18: script parameters
Parameters Description
<1-127> The index of the entry to be used.
usb Creates an USB entry.
<1-8> The unit number in which the USB device is
inserted in, if the unit is a part of the stack.
tftp Creates a TFTP entry.
<hostname | ip> The hostname or IP address of the TFTP
server.
filename The name of the file to be saved.
bootp Indicates script from the
TFTP server,
filename, and IP address obtained using
BOOTP
load-on-boot Specifies the load-on-boot priority. Values
range from 1 to 127. If you omit this
parameter, the entry is created or modified
for manual upload and downloads only.
Use the script upload command to save the contents of the current configuration. The
syntax for the
script upload is:
script upload <1-127>
The script upload command is executed in the Privileged EXEC command mode.
Table 19: script upload parameters on page 86 outlines the parameters for this command.
Table 19: script upload parameters
Parameters Description
<1-127> The index of the entry to be used and must
correspond with the index used to create an
entry.
System configuration using ACLI
86 Configuration — System April 2011
To Next Page
Loading...
