ipv6 interface [address <ipv6_address/prefix_length>]
Variable definitions
Use the data in the following table to help you use the show ipv6 address interface
command.
Variable Definition
vlan <1-4094> Specifies a specific VLAN for which to
display IPv6 addresses.
<WORD 0–45> Specifies the IPv6 address and prefix to be
displayed.
The following table shows the field descriptions for this command.
Table 43: show ipv6 address interface command field descriptions
Field Description
IPV6 ADDRESS Specifies the IPv6 destination address.
TYPE Specifies Unicast, the only supported type.
ORIGIN Specifies a read-only value indicating the
origin of the address. The origin of the
address
is other, manual, DHCP, linklayer, or
random.
STATUS Indicates the status of the IPv6 address. The
values of the status are as follows:
• PREFERRED
• DEPRECATED
• INVALID
• INACCESSIBLE
• UNKNOWN
• TENTATIVE
• DUPLICATE
VID/BID/TID Specifies the VLAN ID corresponding with
the IPv6 address configured.
Configuring IPv6
Configuration — System April 2011 119
To Next Page
Loading...
