Variables Description
neighbor { dot1 [vlan-names |
protocol-id] } | [dot3] [detail] |
med [capabilities | extended-
power | inventory | location |
network-policy]
The neighbor TLVs:
• dot1: displays 802.1
TLVs:
- vlan-names: VLAN Name TLV
- protocol-id: Protocol Identity TLV
• dot3: displays 802.3 TLVs
• detail: displays all TLVs
• med: displays MED TLVs
• capabilities: Displays Capabilities TLVs
• extended-power: Displays extended power TLV
• inventory: Displays Inventory TLVs
• location: Displays Location TLV
• network-policy: Displays Network Policy TLV
neighbor-mgmt-addr Display 802.1ab neighbors management addresses.
pdu-tlv-size
The different TLV sizes and the number of TLVs in an
LLDPDU.
port Port list.
rx-stats The LLDP receive statistics for the local system.
stats The LLDP table statistics for the remote system.
tx-stats The LLDP transmit statistics for the local system.
tx-tlv {dot1 | dot3 | med}
Display which TLVs are transmitted from the local switch
in LLDPDUs:
• dot1: displays status for 802.1 TLVs
• dot3: displays status for 802.3 TLVs
• med: displays status for med TLVs
To display the transmission status of the optional
management TLVs, include only the tx-tlv parameter in
the command.
Job aid: show lldp mgmt-sys-data command
The following
figure displays sample output for the show lldp command with the mgmt-sys-
data variable.
Configuring LLDP using ACLI
Configuration — System April 2011 177
To Next Page
Loading...
