11. In the EndYear dialog box, type a value.
12. In the EndMonth box, select a month.
13. In the EndDay dialog box, type a value.
14. In the EndHour box, select an hour.
15. In the EndMinutes dialog box, type a value.
16. Select the Enabled check box to enable daylight saving time for the switch.
OR
Clear the Enabled check box to disable daylight saving time for the switch.
17. Click Apply .
Variable definitions
Use the data in this table to configure the start and end of the daylight saving time period.
Variable Value
Offset Specifies the time in minutes by which you want to
change the time when daylight savings begins and
ends. The of
fset is added to the current time when
daylight saving time begins and subtracted from the
current time when daylight saving time ends.
TimeZoneAcronym Specifies a time zone acronym.
StartYear Specifies the year from when you want to start the
daylight savings time.
StartMonth Specifies the month of each year from when you want
to start the daylight savings time.
StartDay Specifies the day of the particular month from when
you want to start the daylight savings time.
StartHour Specifies the hour of the particular day from when you
want to start the daylight savings time.
StartMinutes Specifies the minutes of the particular hour from when
you want to start the daylight savings time.
EndYear Specifies the year when to end the daylight savings
time.
EndMonth Specifies the month of each year when to end the
daylight savings time.
EndDay Specifies the day of the particular month when to end
the daylight savings time.
Configuring daylight savings time using EDM
Configuration — System April 2011 279
To Next Page
Loading...
