Avaya 4526FX - Page 195

Modifying the default LLDP Tx interval
Enter configuration commands, one for each line. End with CNTL/Z.
4548GT-PWR-PWR>enable
4548GT-PWR#
configure terminal
4548GT-PWR(config)#lldp tx-interval 60
Checking the new LLDP global settings
4548GT-PWR(config)#show lldp
802.1ab configuration:
----------------------------------------
TxInterval:60
TxHoldMultiplier:4
RxInitDelay:2
TxDelay:2
NotificationInterval:5
MedFastStartRepeatCount:4
Enabling all LLDP Core TLVs for transmission on the router and IP Phone
ports
4548GT-PWR(config)#interface fastEthernet 1/13
4548GT-PWR(config-if)#lldp tx-tlv port 1/13 port-desc
4548GT-PWR(config-if)#lldp tx-tlv port 1/13 sys-name
4548GT-PWR(config-if)#lldp tx-tlv port 1/13 sys-desc
4548GT-PWR(config-if)#lldp tx-tlv port 1/13 sys-cap
4548GT-PWR(config-if)#lldp tx-tlv port 1/13 local-mgmt-addr
Checking the LLDP settings of the router and IP Phone ports
The following represents screen output for the show lldp port 1/13 tx-tlv command:
4548GT-PWR(config-if)#show lldp port 1/13 tx-tlv
LLDP port tlvs
Port PortDesc SysName SysDesc SysCap MgmtAddr
1 true true true true true
13 true true true true true
Configuring LLDP using ACLI
Configuration — System April 2011 195