The syntax for the duplex command is
duplex [port <portlist>] {full | half | auto}
Run the duplex command in Interface Configuration command mode.
The following table describes the parameters for this command.
Table 59: Duplex variables
Variables Description
port <portlist> Specify the port numbers to reset the duplex mode to factory
default values. Enter the port number to configure. The default
value is autonegotiation.
Important:
If you omit this parameter, the system uses the ports you
specified in the interface
command.
full | half | auto Set duplex to
• full: full-duplex mode
•
half: half-duplex mode
• auto: autonegotiation
Important:
Enabling or disabling autonegotiation for speed also enables or disables it for duplex
operation.
When you set the duplex mode for autonegotiation, ensure that the other side of the link is
also set for autonegotiation.
default duplex command
The default duplex command sets the duplex operation for a port to the factory default
duplex value.
The syntax for the default duplex command is
default duplex [port <portlist>]
Run the default duplex command in Interface Configuration command mode.
The following table describes the parameters for this command.
System configuration using ACLI
142 Configuration — System April 2011
To Next Page
Loading...
