cannot progress beyond User EXEC mode, the default mode. If you have read-write access
you can progress from the default mode through all of the available modes.
With sufficient permission, you can use the rules in the following table to move between the
command modes.
Table 1: ACLI command modes
Command mode and
sample prompt
Entrance commands Exit commands
User EXEC
4548GT-PWR>
No entrance command,
default mode
exit
or
logout
Privileged EXEC
4548GT-PWR#
enable exit
or
logout
Global Configuration
4548GT-PWR(config)#
configure terminal mode, enter:
end
or
exit
To exit
ACLI completely,
enter:
logout
Interface Configuration
4548GT-PWR(config-
if)#
interface vlan
From Global Configuration
mode: T
o configure a port,
enter:
interface
fastethernet
<port number> To configure
a VLAN, enter: interface vlan
<vlan number>
To return to Global
Configuration mode, enter:
Exit
To return to Privileged EXEC
mode, enter:
end
To exit ACLI completely,
enter:
logout
For more information, see Avaya Ethernet Routing Switch 4500 Series Fundamentals
(NN47205-102).
Introduction
14
Configuration — System April 2011
To Next Page
Loading...
