no rate-limit command
The no rate-limit command disables rate-limiting on the port.
The syntax for the
no rate-limit command is:
no rate-limit [port <portlist>]
Run the no rate-limit command in Interface Configuration command mode.
The following table describes the parameters for this command.
Table 65: No rate-limit parameters
Parameters Description
port <portlist> Specify the port numbers to disable for rate-limiting. Enter the
port numbers to disable.
Important:
If you omit this parameter, the system uses the port number
you specified in the interface command.
default rate-limit command
The default rate-limit command restores the rate-limiting value for the specified port
to the default setting.
The syntax for the default rate-limit command is
default rate-limit [port <portlist>]
Run the default rate-limit command in Interface Configuration command mode.
The following table describes the parameters for this command.
Table 66: Default rate-limit parameters
Parameters Description
port <portlist> Specify the port numbers to reset rate-limiting to factory default.
Enter the port numbers to set rate-limiting to default.
Important:
If you omit this parameter, the system uses the port number
you specified in the interface command.
General switch administration using ACLI
Configuration — System April 2011 149
To Next Page
Loading...
