6. In the sysName field, type a system name.
7. In the sysLocation field, type a system location.
8. To enable authentication traps, select the Authentication Traps check box.
OR
To disable authentication traps, clear the Authentication Traps checkbox.
9. In the ReBoot section, click a radio button.
10. In the AutoPvid section, click a radio button.
11. In the StackINsertionUnitNumber field, type a value.
12. In the BootMode section, click a radio button.
13. Click Apply .
Variable definitions
Use the data in this table to view and modify the system level configuration.
Variable Value
sysDescr Provides device specific information. This is
a read-only item.
sysUpTime Indicates the amount of time since the
system was last booted.
sysObjectID Indicates the system object identification
number.
This is a read-only item.
sysContact Specifies contact information for the system
administrator, which can include a contact
name or email address.
sysName Specifies a unique name to describe this
switch.
sysLocation Specifies the physical location of this
device.
SerNum Indicates the serial number of this switch .
AuthenticationTraps Enables or disables authentication traps.
• When enabled, SNMP traps are sent to
trap receivers for all SNMP access
authentication.
• When disabled, no SNMP traps are
received.
Reboot Provides the action to reboot the switch.
Configuring system parameters using EDM
Configuration — System April 2011 221
To Next Page
Loading...
