Prerequisites
• Ensure that VLAN is configured before you assign an interface identifier, or an IPv6
address to the VLAN.
•
The Avaya Ethernet Routing Switch 4500 supports port-based and protocol-based
VLANs. For more information about configuring VLANs, see Avaya Ethernet Routing
Switch 4500 Configuration — VLANs, Spanning Tree and Multi-Link Trunking,
(NN47205-501).
Procedure steps
1. From the navigation tree, double-click IPv6.
2. In the IPv6 tree, double-click IPv6.
3. On the work area, click the Interfaces tab.
4. On the toolbar, click Insert.
5. Configure the IPv6 interface.
6. Click Insert.
7. On the toolbar, click Apply.
Variable definitions
Use the data in the following table to create an IPv6 interface.
Variable Value
IfIndex Identifies a physical interface or a logical
interface (VLAN).
For a VLAN, it is the Ifindex
of the VLAN.
Identifier Specifies the IPv6 address interface
identifier, which is a binary string of up to 8
octets in network byte order.
Descr Specifies a text string containing information
about the interface. The network
management system also sets this string.
ReasmMaxSize(MTU) Specifies the MTU for this IPv6 interface.
This value must be same for all the IP
addresses defined on this interface. Value:
1280–9600
System configuration using Enterprise Device Manager
252 Configuration — System April 2011
To Next Page
Loading...
