9. Click Insert.
10. Click Apply .
Variable definitions
Use the data in the following table to help you configure an IPv6 address for a switch or
stack.
Variable Value
IfIndex This is the Ifindex of the VLAN.
Addr Indicates the interface IPv6 address.
AddrLen Indicates the interface IPv6 prefix length.
Type Specifies the interface address type. Values include:
• unicast
•
anycast
Origin Indicates the origin of the interface address. Values include:
• other
• manual
• dhcp
• linklayer
• random
Status Indicates the status of the interface address. Values include:
• preferred
•
deprecated
• invalid
• inaccessible
• unknown
• tentative
• duplicate
Created Indicates the value of the system up time when this address was created.
A value of 0 indicates that this address was created before the last
network management subsystem initialization.
LastChanged Indicates the value of the system up time when this address was last
updated. A value of 0 indicates that this address was updated before the
last network management subsystem initialization.
Configuring an IPv6 address using EDM
Configuration — System April 2011 257
To Next Page
Loading...
