Variable Value
NetAddress Indicates the IP address corresponding to
the media-dependent physical address.
PhysAddress Indicates the media-dependent physical
address. The range is 0–65535. For
Ethernet, this is a MAC address.
Interface Indicates either a physical port ID or the
Multi-Link T
runking port ID. This entry is
associated either with a port or with the Multi-
Link Trunking in a VLAN.
LastUpdated Specifies the value of sysUpTime at the time
this entry was last updated. If this entry was
updated prior
to the last reinitialization of the
local network management subsystem, this
object contains a zero value.
Type Specifies the types of mapping.
• Dynamic type—indicates that the IP
address to the physical address mapping
is
dynamically resolved using, for example,
IPv4 ARP or the IPv6 Neighbor Discovery
Protocol.
• Static type—indicates that the mapping is
statically configured.
• Local type—indicates that the mapping is
provided for the interface address.
The default is static.
State Specifies the Neighbor Unreachability
Detection state for the interface when the
address mapping in this entry is used. If
Neighbor Unreachability Detection is not in
use (for example, for IPv4), this object is
always unknown. Options include the
following:
• reachable—confirmed reachability
• stale—unconfirmed reachability
• delay—waiting for reachability
confirmation before entering the probe
state
• probe—actively probing
• invalid—an invalidated mapping
System configuration using Enterprise Device Manager
260 Configuration — System April 2011
To Next Page
Loading...
