Important
• Always move the Carriage to the right side. If the Carriage is on the left, a Carriage error may
occur when you turn on the printer.
8. Hold
the edge of the roll paper in the middle as you gently pull it evenly to the position of the Ejection Guide
(a). Align the right side of the roll paper with the Paper Alignment Line (b), keeping this side parallel to the line,
and then lower the Release Lever.
Important
• Do
not force the roll paper into alignment with the Paper Alignment Line (b). This may prevent
the paper from being advanced straight.
• If you pull out too much of the roll, an excessive amount will be cut away.
9. Close the Top Cover.
10. Turn the printer on. (See "Turning the Printer On and Off.") →P.652
The roll is now advanced. After it is finished being advanced, you can resume printing.
Note
• You can ensure that the edge is cut neatly by selecting Paper Cutting in the printer menu.
(See "Specifying the Cutting Method for Rolls.") →P.606
Troubleshooting
>
Problems Regarding Paper
>
iPF825 Clearing Jammed Roll Paper
12
789
To Next Page
Loading...
